Instrumentation, model identification and control of an experimental irrigation canal

Author

Sepúlveda Toepfer, Carlos

Director

Rodellar, José

Codirector

Gómez Valentín, Manuel

Date of defense

2008-04-03

ISBN

9788469147474

Legal Deposit

B.37132-2008



Department/Institute

Universitat Politècnica de Catalunya. Institut d'Organització i Control de Sistemes Industrials

Abstract

This thesis aims to develop control algorithms for irrigation canals in an experimental framework.<br/>These water transport systems are difficult to manage and present low efficiencies in practice. <br/>As a result, an important percentage of water is lost, maintenance costs increase and water users follow a rigid irrigation schedule.<br/>All these problems can be reduced by automating the operation of irrigation canals.<br/>In order to fulfil the objectives, a laboratory canal, called Canal PAC-UPC, was equipped and instrumented in parallel with the development of this thesis. In general, the methods and solutions proposed herein were extensively tested in this canal.<br/>In a broader context, three main contributions in different irrigation canal control areas are presented.<br/>Focusing on gate-discharge measurements, many submerged-discharge calculation methods are tested and compared using Canal PAC-UPC measurement data. It has been found that most of them present errors around ±10%, but there are notable exceptions. Specifically, using classical formulas with a constant 0.611 contraction value give very good results (error<±6%), but when data is available, a very simple calibration formula recently proposed in the literature significantly outperform the rest (error<±3%). As a consequence, the latter is encouragingly proposed as the basis of any gate discharge controller.<br/>With respect to irrigation canal modeling, a detailed procedure to obtain data-driven linear irrigation canal models is successfully developed. These models do not use physical parameters of the system, but are constructed from measurement data. In this case, these models are thought to be used in irrigation canal control issues like controller tuning, internal controller model in predictive controllers or simply as fast and simple simulation platforms. Much effort is employed in obtaining an adequate model structure from the linearized Saint-Venant equations, yielding to a mathematical procedure that verifies the existence of an integrator pole in any type of canal working under any hydraulic condition. Time-domain and frequency-domain results demonstrate the accuracy of the resulting models approximating a canal working around a particular operation condition both in simulation and experiment.<br/>Regarding to irrigation canal control, two research lines are exploited. First, a new water level control scheme is proposed as an alternative between decentralized and centralized control. It is called Semi-decentralized scheme and aims to resemble the centralized control performance while maintaining an almost decentralized structure. Second, different water level control schemes based on PI control and Predictive control are studied and compared. The simulation and laboratory results show that the response and performance of this new strategy against offtake discharge changes, are almost identical to the ones of the centralized control, outperforming the other tested schemes based on PI control and on Predictive control. In addition, it is verified that schemes based on Predictive control with good controller models can counteract offtake discharge variations with less level deviations and in almost half the time than PI-based schemes.<br/>In addition to these three main contributions, many other smaller developments, minor results and practical recommendations for irrigation canal automation are presented throughout this thesis.

Keywords

open channels; submerged flow; control systems; system identification; caudal disdrarge measurement; automation; irrigation canals; water levels; flow control; canals; semi-decentralized control

Subjects

004 - Computer science and technology. Computing. Data processing

Documents

01_Sepulveda.pdf

7.113Mb

 

Rights

ADVERTIMENT. L'accés als continguts d'aquesta tesi doctoral i la seva utilització ha de respectar els drets de la persona autora. Pot ser utilitzada per a consulta o estudi personal, així com en activitats o materials d'investigació i docència en els termes establerts a l'art. 32 del Text Refós de la Llei de Propietat Intel·lectual (RDL 1/1996). Per altres utilitzacions es requereix l'autorització prèvia i expressa de la persona autora. En qualsevol cas, en la utilització dels seus continguts caldrà indicar de forma clara el nom i cognoms de la persona autora i el títol de la tesi doctoral. No s'autoritza la seva reproducció o altres formes d'explotació efectuades amb finalitats de lucre ni la seva comunicació pública des d'un lloc aliè al servei TDX. Tampoc s'autoritza la presentació del seu contingut en una finestra o marc aliè a TDX (framing). Aquesta reserva de drets afecta tant als continguts de la tesi com als seus resums i índexs.

This item appears in the following Collection(s)