Neutron-induced fission cross section of 240,242Pu

Author

Salvador Castiñeira, Paula

Director

Pretel Sánchez, Carme

Date of defense

2014-11-07

Legal Deposit

B 28011-2014

Pages

123 p.



Department/Institute

Universitat Politècnica de Catalunya. Institut de Tècniques Energètiques

Abstract

A recent sensitivity analysis done for the new generation of fast reactors [1] has shown the importance of improved cross section data for several actinides. Among them, the neutron-induced fission cross section of 240,242Pu requires a level of accuracy of 1-3% and 3-5%, respectively, from the current status of 6% and 20%. Moreover, nearly all the measurements in the literature have been done relative to 235U(n,f). Therefore, using other references samples such as 237Np or 238U will provide the scientific community with more valuable data. The work was carried out at the Institute for Reference Materials and Measurements (JRC-IRMM). The Van de Graaff accelerator was used for producing a quasi-monoenergetic neutron flux in the energy range of 0.3MeV to 3MeV. Protons were accelerated thanks to a potential difference. A neutron producing target was placed at the end of the beam line: 7Li(p,n)7Be or T(p,n)3He. Then, a twin Frisch-grid ionization chamber (TFGIC) was used as detector. The setup of the detector consists in a common cathode, two anodes and two grids. In the cathode the sample under study and the reference sample are placed in a back-to-back configuration. Each electrode is connected to a preamplifier, and then to a 100MHz 12 bit waveform digitizer. All raw signals are stored for an offline analysis using C++ under the ROOT framework. All the samples used were produced by the target preparation group at JRC-IRMM. The enrichment of the plutonium samples was of 99.89% for 240Pu and of 99.97% for 242Pu. The plutonium masses were chosen to minimize their alpha activity (0.8MBq for 240Pu and 0.1MBq for 242Pu). Three different reference fission cross sections were employed: 235U(n,f), 238U(n,f) and 237Np(n,f). The mass of all the reference samples used was remeasured by means of low geometry alpha counting or/and by a single grid ionization chamber. The mass uncertainty of each sample was lower than 2%. Results were obtained not only for the neutron-induced fission cross section of 240,242Pu in the region from 0.3 MeV up to 3 MeV, but for the 238U(n,f) cross section and the 237Np(n,f) cross section. The neutron flux from the Van de Graaff was characterized by means of MCNP simulations. A clear influence of the different structures between the neutron producing targets and the deposits was found, specially when the ratios measured involved a fissile sample and a threshold sample. The spontaneous fission of 240,242Pu is, as well, an important correction. Thus, this property was measured independently in this work, reaching an uncertainty lower than 1.3% for both isotopes. More corrections were due to the high electronic threshold needed to not trigger on alpha particles, the fission fragment loss due to the sample thickness, neutron emission anisotropy, etc. On average the results of the 240,242Pu(n,f) cross section are in agreement with previous experimental data, even though the trend is slightly lower than present evaluations. In the case of 242Pu(n,f) cross section the resonance-peak structure at 1.1 MeV could not be reproduced in any case. The results of the 237Np(n,f) cross section show an increase at the plateau region with respect to the ENDF/B-VII.1 evaluation in the same way as the data from Paradela (2010) [2]. The results for the 238U(n,f) cross section show a higher cross section than the ENDF evaluation but in agreement with the present JEFF 3.2 evaluation. [1] Uncertainty and target accuracy assessment for innovative systems using recent covariance data evaluations, Volume 26, 2008, OECD-NEA [2] Paradela, C. et al., Neutron-induced fission cross section of U-234 and Np-237 measured at the CERN Neutron Time-of-Flight (n_TOF) facility.,Physical Review C. 82, 3, 034601 (2010)


Un anàlisi de sensitivitat [1] recent per la nova generació de reactors ràpids va mostrar la importància de millorar les seccions eficaç de varis actínids. Entre ells, la secció eficaç de fissió per neutró induït del 240,242Pu requereix una millora en la seva precisió des d'un 6% a un 1-3% pel 240Pu i des d'un 20% a un 3-5% pel 242Pu. A més, quasi bé totes les dades experimentals disponibles a la literatura han estat determinades relatives a la secció eficaç del 235U(n,f). Per tant, la utilització d'altres isòtops com a referències, tal com el 237Np(n,f) o el 238U(n,f), proveirà a la comunitat científica amb dades valuoses. Aquest treball ha estat realitzat a l'Institute for Reference Materials and Measurements (JRC-IRMM). L'accelerador Van de Graaff disponible al JRC-IRMM s'ha emprat per produir un flux de neutrons quasi mono-energètics en el rang de 0.3 MeV a 3 MeV. Els protons van ser accelerats de fer-los impactar amb una mostra de producció de neutrons: 7Li(p,n)7Be o T(p,n)3He. A continuació, una doble cambra d'ionització amb grid (TFGIC) es va emplaçar com a detector consistent en un càtode, dos ànodes i dos grids. En el càtode es situen la mostra a estudiar i la mostra de referència. Cada un dels elèctrodes és connectat a un preamplificador i, a continuació, a un digitilitzador amb una freqüència de 100 MHz i 12 bit. Les senyals originals són emmagatzemades sense cap tractament previ per a un posterior anàlisi. El tractament de dades es va realitzar mitjançant el codi de programació C++ sota el marc de ROOT. Totes les mostres emprades en aquest experiment s'han produït al grup de preparació de mostres del JRC-IRMM. L'enriquiment de les mostres de plutoni era de 99.89% pel 240Pu (0.8MBq) i del 99.97% pel 242Pu (0.1MBq). La massa de les tres mostres de referència (235U(n,f), 238U(n,f) i 237Np(n,f)) també va ser mesurada. La incertesa de cada massa és inferior al 2%. La principal correcció aplicaca als resultats obtinguts ha estat per la caracterització del flux de neutrons mitjançant el codi de simulació Monte Carlo MCNP. Els resultats de les simulacions han mostrat una clara influència de les diferents estructures emplaçades entre la mostra de producció de neutrons i les mostres de fissió. Altres correccions s¿han realitzat per la fissió espontània del 240,242Pu (mesurada independentment en aquest treball amb una incertesa inferior al 1,3%), la deficiència d'esdeveniments a causa del llindar de detecció, l'eficiència del detector, l'anisotropia en l'emissió dels neutrons, etc. Tot i que el principal objectiu va ser l'obtenció de la secció eficaç de fissió per neutró induït del 240,242Pu en la regió de 0.3 MeV a 3 MeV, resultats addicionals han estat obtinguts per la secció eficaç del 238U(n,f) i el 237Np(n,f). Els resultats obtinguts mostren un acord significatiu entre la secció eficaç del 240,242Pu(n,f) i resultats experimentals anteriors, tot i que la tendència és lleugerament inferior a les avaluacions (ENDF/B-VII.1, JEFF 3.1 i JENDL 4.0) disponibles. En el cas de la secció eficaç del 242Pu(n,f), a més, el pic de ressonància al voltant de 1.1 MeV predit per quasi totes les dades experimentals anteriors i les avaluacions actuals no s'ha reproduït en aquest experiment. Els resultats de la secció eficaç del 237Np(n,f) presenten un increment en la regió plana després del llindar de fissió d'un 5-7% respecte l'avaluació ENDF/B-VII.1, i en concordança amb els resultats obtinguts per Paradela (2010) [2]. Finalment, els resultats de la secció eficaç del 238U(n,f) mostren un increment al voltant d'un 7-9% a la zona plana després del llindar de fissió, aquesta predicció concorda amb l'avaluació JEFF 3.2. [1] Uncertainty and target accuracy assessment for innovative systems using recent covariance data evaluations, Volume 26, 2008, OECD-NEA [2] Paradela, C. et al., Neutron-induced fission cross section of U-234 and Np-237 measured at the CERN Neutron Time-of-Flight (n_TOF) facility.,Physical Review C. 82, 3, 034601 (2010)

Keywords

Neutron-induced fission cross section; 240Pu; 242Pu; 237Np; 238U; Spontaneous fission half-life; Ionization chambers; Accelerator

Subjects

53 - Physics; 621 - Mechanical engineering in general. Nuclear technology. Electrical engineering. Machinery

Documents

TPSC1de1.pdf

6.683Mb

 

Rights

L'accés als continguts d'aquesta tesi queda condicionat a l'acceptació de les condicions d'ús establertes per la següent llicència Creative Commons: http://creativecommons.org/licenses/by/3.0/es/
L'accés als continguts d'aquesta tesi queda condicionat a l'acceptació de les condicions d'ús establertes per la següent llicència Creative Commons: http://creativecommons.org/licenses/by/3.0/es/

This item appears in the following Collection(s)